A polyurethane based topcoat for all areas above the waterline. The product provide excellent durability and offers superior gloss and colour retention.

• all areas above the waterline.

Transurethane Finish can be applied on suitable Transpoxy priming systems. A typical system for atmospheric exposure is shown below.

Transpoxy Master bond 4.67 1 x 50 µ dft

Transurethane Finish 3.43 1-2 x 40 µ dft

(1) The surface should be dry and free from contaminants prior to overcoating. The best intercoat adhesion is achieved when the subsequent coat is applied before the preceding coat is fully cured. After prolonged exposure times it may be necessary to roughen the surface to ensure intercoat adhesion. When in doubt, consult your nearest Transocean office.

Surface preparation.

Coated Substrates Existing systems should be dry and free from loose paint, salt , grease and other contaminants prior to overcoating.

Oil and grease should be removed by solvent cleaning according to SSPC-SP1.

Remove salts and dirt by fresh water washing.
Corroded areas should be repaired first with an appropriate primer system.

Observe the precautionary notices on the label of the container. A material safety data sheet is available upon request and national or local safety regulations should be followed. This product is intended for use by professional applicators.

As a general rule, avoid skin-and eye contact by wearing overalls, gloves, goggles, mask, etc. Spillage on the skin should immediately be removed by thorough washing with lukewarm water and soap or a suitable industrial cleaner. Eyes should be flushed with fresh water and medical attention sought immediately.

Spraying should be carried out under well-ventilated conditions. Avoid inhalation of solvent vapours and paint mist by wearing an air mask.

This product contains flammable materials and should be kept away from sparks and open flames. Smoking in the area should not be permitted.