A high Solids epoxy primer/coating formulated with Masterbond binder technology. Transpoxy Masterbond its excellent anticorrosive properness and good impact - and abrasion resistance. Good adhesion to be prepared steel substrates and compatible with most aged coatings.

Steel
Oil and grease should be removed by solvent cleaing according to SSPC - SP1.
Remove weld spatter and smooth weld seams and sharp edges as applicable.
Abrasive blasting: min.Sa2- ISO 8501:1.
Power tool cleaning:min. ISO-St3.

please note that better surface preparation Always results in longer liftime expectations.
Apply Transpoxy Masterbond immediately after the steel has been blasted and the quality of preparation has been approved.

Repair Existing systems should be roughened and free from loose paint, sait, grease and other contaminants prior to overcoating.

Corroded and/or damaged areas should be power tool cleaned to ISO-ST2 or Better or blast cleaned to ISO-SA2.

Observe the precautionary notices on the label of the container. A material safety data sheet is available upon request and national or local safety regulations should be followed.

his product is intended for use by professional applicators.
As a general rule, avoid skin-and eye contact by wearing overalls, gloves, goggles, mask, etc. Spillage on the skin should immediately be removed by thorough washing with lukewarm water and soap or a suitable industrial cleaner.

Eyes should be flushed with fresh water and medical attention sought immediately. Spraying should be carried out under well-ventilated conditions. Avoid inhalation of solvent vapours and paint mist by wearing an air mask.

This product contains flammable materials and should be kept away from sparks and open flames. Smoking in the area should not be permitted.