Si - Patine is a glazed coating used to create decorative and attractive finish techniques. It is a water based Latex formula, it is easy to apply with a special painting tools to create the fantasy finishes like sponging, rag rolling or dragging which enhance beauty and pleasure to place.

Si- Patine can be used for interior walls, ceilings, wood surfaces which is need very fine touch of decoration like villa, royals, receptions, restaurants, hotels, airports. Si-Patine offers long open time for negative techniques when decorating large surfaces, so it can be used to decorate on emulsion or enamel surfaces.
Si – Patine is independent surface preparation when apply thick layer with excellent filling properties will cover all minor surface imperfection.

The surfaces should be dry, clean and free from contaminates such as grease, oil, dust, which can result in poor adhesion of the paint to the surface. Use a suitable solvent for cleaning, old flaking paint or poorly bound surfaces must be removed completely.

New Surfaces:

Wood Surfaces:
Prepare surface by use one coat of diluted Luxury Undercoat 313, then one coat of Latex Wall Putty and finish preparation with one coat of Si – Tone700, then allow the surface to dry and apply Si- Stucco with Putty knife or steel trowel.

Cement And Gypsum Surface:
Prepare the surface with one coat of Latex Sealer 1800, then one coat of Latex Wall Putty and finish preparation with one coat of Si-Tone 700, then allow the surface to dry and apply Si-Stucco with putty knife or steel trowel.

Old Painted Surfaces:

Wood Surfaces:
Use sanding paper to release any grease or loosing materials, flaks and defected painted surface then prepared surface as on the previous new wood surface.

Cement And Gypsum Surface:
Clean up surface well with water and soap several times, then wash with clean water to insure surface is free, fine, then allow to dry and apply as in previous new cement & gypsum surfaces.
System Of Application:

Apply Si-Stucco after surface preparation - by using Putty knife with a (specified shape) separated by wholes and after during (1 hr) apply another coat in the wholes between the first coat (you can use 2 coats or more of Stucco) then, after 2 hours use the edge of Putty knife to press the whole area to get the fine shade of Stucco application.